This is a project where I built a 3d printed Bluetooth Arrow Keypad. Check out the project on makerworld: https://makerworld.com/de/models/3524293-bluetooth-page-turner-pedal
Getting Started
-
Download and install the Arduino IDE.
-
Connect the ESP with an USB-C cable and select your board (ESP32 Dev Module) and the correct port on your computer.
-
Open the sketch BLETurner.ino.
-
Flash the code to your ESP32-WROOM-32.
-
Check whether it starts pairing and establishing a Bluetooth connection
-
Test arrow keys by shortly connecting GND with GPIO14/GPIO27