Skip to content

Baseplates: a dovetail plate with a 2.34 mm deep counterbore fails to build one piece at 39.07 mm #76

Closed

Description

@Oliver-Johnson

Found by the review of #69. It is on main (3145cc7).

What happens. With the default dovetail at a 39.07 mm pitch, auto margins and screws with a counterbore 2.34 mm deep, the second piece never builds. The page lists only A1, Download stays off, and Checks shows nothing to say why. The review traced it to the end-of-build seam repair throwing "T-junctions still appearing" on B1.

Repro (Baseplates page):

  • #pi=39.07&w=170&d=90&bw=100&bd=400&cn=dovetail&sc=1&sh=3&se=2.34&sd=8: only A1 appears, with Download off and no warning. The same happens with sd=7.5 and sd=9, and with w=164.
  • The same with se=2: A1 and B1 both build clean and Download is on.

The review saw it for heads from 7.5 to 9.4 mm. #69's new limit still takes some of these sizes.

Two things to fix.

  1. The build itself. The counterbore's ceiling at 2.34 mm is near the dovetail notch's 2.4 mm ceiling, so it is probably the near-level faces Plates: keep magnet and screw pockets out of a joint's cut in the floor #69 describes, but that isn't confirmed.
  2. The page's silence. When a piece fails to build, Checks should say so, with the piece's name, rather than leaving Download off with no reason.

Metadata

Metadata

Labels

bugSomething isn't working

Projects

No projects

    Milestone

    No milestone

    Relationships

    None yet

    Development

    No branches or pull requests

    Issue actions