You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
{{ message }}
Repository navigation
Baseplates: a screw head only slightly wider than its shank leaves hundreds of bad edges #73
Found by the sweep for #69. It is on main (3145cc7) and does not depend on the joint.
What happens. When the screw head is only a hair wider than the shank, the counterbore and the shank hole cross each other. The plate then builds with hundreds of bad edges, Checks gives no warning, and Download stays on.
Repro (Baseplates page, two pieces, no joint, screws on with a 2 mm shank):
#pi=37.67&w=150.68&d=75.34&mm=custom&ml=0&mr=0&mf=0&mb=0&bw=91.34&bd=400&sc=1&sh=2&sd=2.03&cn=none: A1 and B1 have 196 bad edges each.
The same at 42 mm (pi=42): 98 and 49.
With sd=2.1 or sd=2.5: both pieces are clean.
With a snap joint (cn=snap) it is the same 196 and 196.
Cause (from the sweep, not traced in the code). The head is cut as a 14-sided polygon and the shank as a 12-sided one. At 2.03 mm over 2 mm, the head's flats cross the shank's corners, so the two cuts' walls interleave around the hole instead of one sitting inside the other.
Possible fix. Treat a head that doesn't clear the shank's corners as no counterbore, or refuse it in Checks. The minimum would be the shank's corner circle plus a margin; screw bores are being reworked in the screw-pocket PR (flats on the typed size), so the threshold should follow that shape. Then add an audit row at 2.03 over 2.
Activity
Merge main (#78) into claude/screw-flats-clearance
Say at the screw head field when a head too narrow to clear its shank…