Printing
NOTE: If you plan on using the Tapchanger Dragonburner dock you must use the custom cowl by OstroMa. We always recommend to use the original cowls when possible and the Modular Dock does not require any special Cowl, print the original from the Dragonburner repo.
Coming Soon
All print settings are the same as Voron Standards or better.
Since every filament shrinks at a different rate and our tolerances are too tight to allow for "pre-scalling". You need to calibrate the shrinkage for each and every filament you use, even the same brand but different colour can shrink at a different rate. We recommend using Califlower for each filament.
- Shuttle is the only part that requires supports and should be set to
touching build plate
Print orientation is flat on the parts back with supports enabled currently, we are working on models with integrated supports.
- All stls are in the proper print orientation
