Being able to pause and go back similar to how you can with OpenPnP placements would be a massive benefit. I have found that some pads occasionally get no solder, and some get way too much and if noticed prior to removing the board from the assembly platform, being able to go back would be great rather than having to stop and restart the entire job where you may end up with the same problem elsewhere.
Currently with the only options being "run the whole job" requires a single successful run across the entire PCB which at this stage in the software and hardware is just not realistic.
Being able to pause and go back similar to how you can with OpenPnP placements would be a massive benefit. I have found that some pads occasionally get no solder, and some get way too much and if noticed prior to removing the board from the assembly platform, being able to go back would be great rather than having to stop and restart the entire job where you may end up with the same problem elsewhere.
Currently with the only options being "run the whole job" requires a single successful run across the entire PCB which at this stage in the software and hardware is just not realistic.