Hello, this is a general request, not only for bcm2-utils. I have a FAST3890 here, I've found that it has two uarts (I think?) but I can't get into any bootloaders. I only see a GO! and then a kernel boot.
Even if I keep pressing a key (enter, spacebar, etc), nothing changes. I think the serial is disabled, OR it's not on that port. I checked the solder and it's not shorting anything, it just doesn't accept my input.
On the logs, it reaches to a login from a yocto build, which could accept input, but doesn't. The log continues, finishing in bfcSerialConsoleMode set to disabled, disabling console. Goodbye....
log-truncated.txt
Using the "dump" feature and the ip of the device DOESN'T work! (I guess telnet is not enabled).
What can I do in this scenario? Thank you!
Hello, this is a general request, not only for bcm2-utils. I have a FAST3890 here, I've found that it has two uarts (I think?) but I can't get into any bootloaders. I only see a GO! and then a kernel boot.
Even if I keep pressing a key (enter, spacebar, etc), nothing changes. I think the serial is disabled, OR it's not on that port. I checked the solder and it's not shorting anything, it just doesn't accept my input.
On the logs, it reaches to a login from a yocto build, which could accept input, but doesn't. The log continues, finishing in
bfcSerialConsoleMode set to disabled, disabling console. Goodbye....log-truncated.txt
Using the "dump" feature and the ip of the device DOESN'T work! (I guess telnet is not enabled).
What can I do in this scenario? Thank you!